Bosch Rexroth IndraMotion MTX micro - Page 98

● b) Correct the "Amplitude" value which should not exceed the rec‐
ommended value (2).
● c) Turn on power to the drives.
●
d) Click on "Enable" (3).
● e) Click on "Start Measurement" (4).
● f) After completed measurement, click on "Display Result Graphical‐
ly" (5).
Fig.8-9: Frequency response analysis
4. Fig. 8-10 shows the amplitude and phase responses determined after the
measurement of the frequency response. Two resonance points have
been determined at 63 Hz and 899 Hz.
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
96/141
Commissioning the Drives