Setting up and connectingde
1.Please refer to the assembly
instructions provided for the
necessary steps.
2.Connect the device to the drinking
water connection using the
included parts.
The technical data
→
Page 65
observe.
3.Make sure that the drinking water
connection is not kinked, crushed or
twisted.
5.5 Electrical connection
Connect your device to the power
supply.
Connect the device electrically
Hints
¡Observe the safety instructions
wise →
page 4
.
¡Just plug in the device
AC voltage in the range of 220 - 240
V and 50 Hz or 60 Hz.
¡Please note that the water
Safety system only works when
there is power supply.
1.Insert the cold appliance plug into the
mains connection cable into the
device.
2.Plug the device's power plug into a
power outlet near the device.
The connection data of the
device is on the nameplate.
3.Check that the power plug is firmly
seated.
15
To Next Page
Loading...
