deCleaning and care
3.Pull the micro sieve downwards.
17.7 Clean spray arms
Limescale and impurities from the
rinse water can block the nozzles and
bearings of the spray arms. Clean the
spray arms regularly.
1.Unscrew the upper spray arm and
pull it downwards.
4.Press the locking lugs together and
remove the coarse sieve
upwards.
1
2
2
1
2.Pull the lower spray arm upwards.
5.Clean the sieve elements under
running water.
Carefully clean the dirt edge
between the coarse sieve and fine
sieve.
6.Assemble the sieve system.
Please note that the locking lugs on
the coarse sieve are engaged.
3.Check the outlet nozzles of the spray
arms for blockages under running
water and remove foreign bodies if
necessary.
7.Insert the sieve system into the
device and turn the coarse sieve
clockwise.
4.Insert the lower spray arm. aThe
spray arm audibly clicks into place.
Note that the arrow marks are
opposite each other.
5.Insert the upper spray arm and
screw it tight.
48
To Next Page
Loading...
