deSoftening system
A notice:Set your device to the
determined water hardness level.
→
"Setting the softening system",
page 32
If the water hardness level is 0 - 6 °dH,
you can do without special salt and
switch off the softening system.
→
"Switch off the softening system",
page 33
The higher the water hardness, the
higher the amount of special salt
required.
DANGER!
Cleaner can damage the softening
system.
▶ Only fill the storage container of
the softening system with special
salt for dishwashers.
Special salt can damage the washing
container through corrosion.
▶ To ensure that overflowed special
salt is rinsed out of the rinsing
container, fill the special salt into the
special salt storage container
immediately before the program
starts.
11.2 Setting the softening
system
Set the device to the water hardness
level.
1.Determine the water hardness level
and the appropriate setting value.
→
"Overview of the water
hardness settings", page 31
1.Unscrew and remove the lid from
the special salt storage container.
2. press.
3.Hold down program button A and
Press until the display
shows H:xx.
2.When using for the first time: Fill
the storage container completely
with water.
4.Program button A and
sen.
let go-
aThe program button A flashes and
the display shows H:04.
5.Press program button C repeatedly
until the appropriate water hardness
level is set.
6.To save the setting, press .
11.3 Special salt
You can soften water with special
salt.
Pour in special salt
If the special salt refill indicator lights
up, fill special salt into the special salt
storage container immediately before
starting the program. The amount of
special salt required depends on the
degree of water hardness. Je
32
To Next Page
Loading...
