Basic settingsde
basic
position
Display text
I:011
Selection
I:00 - I:01
Description
InfoLight Switch InfoLight on or off.
While the program is
running, a spot of light
appears on the floor below
projected onto the appliance
door. When installed high
with a flush furniture front,
the light point is not visible. If
the light spot flashes, the
appliance door is not fully
closed. When the light spot
on the floor is no longer
visible, the program is
finished.
The level "I:00" switches the
InfoLight off.
Signal volume b:021 b:00 - b:03 Control the signal volume.
Acoustic indication of the end
of the program with a signal
tone.
The level "b:00" switches off
the signal tone.
1Factory setting (may vary depending on device type)
16.2 Change basic settings
You can change several settings.
7.To save the setting, press .
1.Open the device door.
2. press.
8th.Close the device door.
3.Hold down program button A and
Press until the display
shows H:xx.
4.Program button A and
sen.
let go-
aThe program button A flashes and
the display shows H:04.
5.Press program button A repeatedly
until the display shows the
desired setting.
6.Press program button C repeatedly
until the display shows the
appropriate value.
45
To Next Page
Loading...
