deservice
15.6 Start program
2. approx. 3 seconds
press.
3.Close the device door.
▶ press.
aThe program is finished when
the display shows "0:00".
aThe program is aborted
and is completed after approx. 1
minute.
Hints
¡If you during operation
If you want to add more dishes, do
not use the tab drip tray as a handle
for the upper dish rack. You might
come into contact with the partially
dissolved tab.
¡You can view the current program
Only change the program if you
cancel the program.
→
"Cancel program", page
42
¡To save energy, switch
The device switches off 1 minute after
the end of the program. If you open the
device door immediately after the end
of the program, the device switches off
after 4 seconds.
15.9 Switch off the device
1.The instructions for safe use →
Page 11
observe.
2. press.
3.To avoid damage caused by
escaping water, close the tap
completely (not necessary for
devices with Aqua-Stop).
Tip:If you press during the rinse cycle,
the current program will be
interrupted. When you turn on the
device, the program continues
automatically.
15.7 Interrupt program
A notice:If you open the appliance door
when the appliance is heated up, leave the
appliance door ajar for a few minutes and
then close it. This will prevent excess
pressure from building up in the device
and causing the device door to pop open.
1. press.
aThe program is saved
and the device switches off.
2.To continue the program, press .
15.8 Cancel program
To end a program prematurely or to
change a program that has been
started, you must cancel it.
1.Open the device door.
42
To Next Page
Loading...
