cleanserde
3.If rinse aid has overflowed, remove
it from the rinse container.
12.3 Switch off the rinse aid
system
Overflowing rinse aid can lead to
excessive foam formation during
the rinse cycle.
If the rinse aid refill indicator bothers
you, for example if you use combined
detergents with a rinse aid
component, you can switch off the
rinse aid system.
4.Close the lid of the rinse aid
reservoir.
aThe lid clicks into place audibly.
Tip:The function of the rinse aid is
limited with combined detergents. If
you use rinse aid, you will usually
achieve better results.
12.2 Adjust the amount of rinse
aid added
If streaks or water stains remain on
the dishes, change the amount of rinse
aid added.
1. press.
1. press.
2.Hold down program button A and
Press until the display
shows H:xx.
2.Hold down program button A and
Press until the display
shows H:xx.
3.Program button A and
sen.
let go-
aThe program button A flashes and
the display shows H:04.
3.Program button A and
sen.
let go-
4.Press program button A repeatedly
until the display shows the factory-
set value r:05.
aThe program button A flashes and
the display shows H:04.
4.Press program button A repeatedly
until the display shows the factory-
set value r:05.
5.Press program button C repeatedly
until the display shows r:00.
6.To save the setting, press .
5.Press program button C repeatedly
until the appropriate amount of
rinse aid has been added.
aThe rinse aid system is switched off
switches on and the rinse aid refill
indicator is deactivated.
– A low setting adds less rinse aid
to the wash cycle and reduces
streaks on the dishes.
– A higher level adds more rinse
aid to the rinse cycle, reduces
water stains and produces a
better drying result.
13 cleaners
Find out which cleaners are suitable
for your device.
13.1 Suitable cleaners
6.To save the setting, press .
Only use cleaner that is suitable for
dishwashers. Both solo cleaners and
combined cleaners are suitable.
To achieve optimal rinsing and
drying results, use solo cleaners in
conjunction with
35