Softening systemde
3. Note:Only use special salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
1. press.
2.Hold down program button A and
Press until the display
shows H:xx.
Pour the special salt into the storage
container.
3.Program button A and
sen.
let go-
aThe program button A flashes and
the display shows H:04.
4.Press program button C repeatedly
until the display shows H:00.
a
5.To save the setting, press .
aThe softening system is equipped
switches on and the salt refill
indicator is deactivated.
11.5 Regenerating the
softening system
funnel
1
Fill the storage container completely
with special salt. The water in the
storage container is displaced and
drains away.
In order to maintain the trouble-free
function of the softening system, the
device regenerates the softening
system at regular intervals.
The softening system is regenerated
in all programs before the end of the
main rinse cycle. The running time and
consumption values increase, e.g. B.
Water and electricity.
4.Place the lid on the storage
container and screw it on.
11.4 Switch off the softening
system
Notice
To avoid damage to the device, only
switch off the softening system in the
following cases: ¡The water hardness
level is maximum
times 21 °dH and you use a
combined cleaner with salt
substitutes. According to the
manufacturer, you can usually only
use combined cleaners with salt
substitutes up to a water hardness
of 21 °dH without adding special
salt.
¡The water hardness level is 0 -
on special salt6 °dH. You can do
without.
1Depending on the device reimbursement
33
To Next Page
Loading...
