Solution16
Plus
14
Bosch Security Systems 03/10 BLCC100U
User Guide
Areas > Commands >
Turn Area On/O
MENU 2-0-1
This menu allows you to turn an area All On or o.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [1].
A list of dierent areas will display on the keypad.
A001 Reception Area
A002 Sales Dept
A003 Administration Dept
Press
, OK or MENU
If an area has already been turned All On or Part On, a
‘tick’ () will be displayed on the right side of the name
description (see A002 Sales Dept above).
2. Use the [] and [] keys to select the area that you want
to turn on or o, then press [OK] to select. Alternatively,
you can enter the area number you want to turn on or o,
then press [OK].
Areas > Commands >
Turn All Areas On
MENU 2-0-2
This menu allows you to turn on all areas that your PIN has been
assigned to at the same time All On. The keypad display below
shows the area icons 1 through to 4.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [2].
The keypad will display the exit time bar to prompt you
to exit all areas. You should leave all areas now.
Area 1 Name
EXIT
NOW
When exit time has expired, the keypad will display that
all areas are turned All On (Armed).
Area icons will only display if programmed to
do so by your security installer.
Areas > Commands >
Turn All Areas O
MENU 2-0-3
This menu allows you to turn o all areas that your PIN has been
assigned to at the same time. However, this menu requires at
least one area that has a keypad assigned to it to be disarmed
before you can access this command.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [3].
Areas > Commands >
Move To Area
MENU 2-0-4
This menu allows you to operate multiple areas from the same
keypad when the system has been partitioned. Before operating
a dierent area, you will need to move the keypad to the area
that you want to operate.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [4].
A list of dierent areas will display on the keypad.
A001 Reception Area
A002 Sales Dept
A003 Administration Dept
Press
, OK or MENU
2. Use the [] and [] keys to select the area that you want
to move the keypad display to, then press [OK] to select.
Alternatively, you can enter the area number that you
want to move the keypad display to, then press [OK].
Areas > Commands >
Chime On/O
MENU 2-0-5
Chime mode allows you to monitor a zone (or group of zones)
to sound the keypad buzzer or activate a programmable output
when the corresponding area is turned o (disarmed). This can
be useful when you need to monitor the front or back entrance
to the premises.
This menu allows a user to turn chime mode on or o. Only
keypads programmed to sound the chime tone will be heard
when a zone programmed for chime is faulted.
The master user can Set Chime Zones on page 16. This allows
the master user to program which zones can be monitored for
chime.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [5].
A list of dierent areas will display on the keypad.
A001 Reception Area
A002 Sales Dept
A003 Administration Dept
Press
OK or MENU
To Next Page
Loading...
