Bosch Solution 16plus - Remote Access and Dialler Options; Call Forward, SMS, and Dialer Settings; Remote Access Configuration

19
Bosch Security Systems 03/10 BLCC100U
Solution16
Plus
User Guide
Outputs > Properties >
Output Name
MENU 4-1-0
This menu allows you to program the name for each output.
Each output name supports up to 16 characters.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [1] + [0].
A list of dierent outputs will display on the keypad.
2. Use the [] and [] keys to select the output name
that you want to change, then press [OK] to select.
Alternatively, you can enter the output number, then
press [OK].
The keypad will display the following:
Output Name O001
Output 1
Press
 OK to SAVE
3. Use the [] and [] keys to scroll the cursor left and right
across the output name text. Use the [] and [] keys to
scroll through the dierent characters available. To clear
all text from the cursor position to the right, press the
[OFF] key.
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Outputs > Output Testing >
External Siren Test
MENU 4-9-0
This menu allows you to test any external sirens which have been
connected by your installer. The test will last for 5 seconds.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [0].
If the system has been partitioned, the keypad will
display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS
 OK or MENU
2. Use the [] and [] keys to select the area that you want
to test the siren, then press [OK]. Alternatively, you can
enter the area number, then press [OK].
The keypad will display the following during the siren
test.
External Audible
Testing Press any key to
abort
Press OK or MENU
When the siren test is complete, the keypad will display
the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >
Internal Siren Test
MENU 4-9-1
This menu allows you to test any internal sirens which have been
connected by your installer. The test will last for 5 seconds.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [1].
If the system has been partitioned, the keypad will
display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS
 OK or MENU
2. Use the [] and [] keys to select the area that you want to
test the bell, then press [OK]. Alternatively, you can enter
the area number, then press [OK].
The keypad will display the following during the bell test.
Internal Audible Testing
Press any key to abort
Press OK or MENU
When the bell test is complete, the keypad will display
the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >
Strobe Test
MENU 4-9-2
This menu allows you to test the external strobe light.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [2].
If the system has been partitioned, the keypad will
display a list of areas.
A001 Area 1 Name
A002 Area 2 Name
A003 Area 3 Name
PRESS
 OK or MENU