Bosch Solution 16plus - Dialler Reporting; Transmission Formats, Routes, and Delays

Solution16
Plus
20
Bosch Security Systems 03/10 BLCC100U
User Guide
2. Use the [] and [] keys to select the area that you want to
test the strobe, then press [OK].
Alternatively, you can enter the area number, then press
[OK].
The keypad will display the following during the strobe
test.
Strobe Activated. Will
Reset On exit
Press OK or MENU
Check and verify that the strobe light is on.
3. Press [OK] to exit.
Communication / Reporting
Programming options in this section relate to how you alarm
system will communicate alarm information. Your installer will
advise you on the exact makeup and conguration of your
system.
Comms > Commands >
Call/Answer RAS
MENU 5-0-1
This menu allows you to initiate a modem call to the installer’s
o-site computer for programming changes or updates. Your
installer may request that you enter this command so that they
can remotely service and congure you system. You should not
enter this command unless requested to do so.
Comms > Commands >
Call Forward On/O
MENU 5-0-2
This menu allows you to turn on and o the call forward feature.
When you turn on call forwarding, the Solution 16
Plus
control
panel will automatically activate and de-activate the call forward
on and call forward o sequence accordingly when you turn
Area 1 All On and o (arm and disarm).
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [0] + [2].
If the call forward status is o, the keypad will display:
Call Forward On/Off
Call Forward is OFF,
To turn ON, Press ON.
To Go Back Press OK
If the call forward status is on, the keypad will display:
Call Forward On/Off
Call Forward is ON,
To turn OFF, Press OFF.
To Go Back Press OK
2. To toggle call forward on, press the [ON] key or press the
[OFF] key to turn call forward o.
3. Press [OK] to save and exit, or press [MENU] to cancel.
Comms > Commands >
Check Web Email
MENU 5-0-3
Reserved for future use
Comms > Commands >
Email System Log
MENU 5-0-4
Reserved for future use
Comms > Commands >
Voice Setup
MENU 5-0-6
This menu allows the master user to record their own customised
greeting and zone description message that will be played back
to users that are programmed to receive domestic telephone
calls from the alarm system.
These messages should be clear enough so that the user
receiving the telephone call from the control panel can then take
the appropriate action.
This feature requires an optional voice module to be tted to
the control panel by your installer. Additional programming
information is included with the voice module.
Comms > Commands >
Set Domestic Phone Number
MENU 5-1-5
Domestic reporting allows the Solution 16
Plus
control panel
to send reports to personal telephone numbers (eg. mobile
telephone numbers). Up to three dierent telephone numbers
can be programmed, each having a maximum of 32 digits.
A telephone call needs to be acknowledged by the user that
answers the incoming call. If the user fails to acknowledge the
call, the Solution 16
Plus
control panel will make another attempt to
report until the maximum number of call attempts are reached.
To acknowledge the call, the user needs to press the [#] key on
their telephone.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [1] + [5].
If the control panel is congured to report via domestic
format, the keypad will display the following:
Domestic Reports Not
Enabled. Please contact
Your Security Service
Provider
If the control panel has been congured to report via
domestic format, the keypad will display information for
telephone number 1.
Domestic Phone Number 1
631728_
Press
 0-9 OK to SAVE