Bosch Solution 16plus - System Configuration; Panel, Clock, Timers, and Power

23
Bosch Security Systems 03/10 BLCC100U
Solution16
Plus
User Guide
Communications Test
Successful
If the test is NOT successful, the keypad will prompt:
Test Report Failed
Please call for service
Press OK or MENU
2. Press [OK] or [MENU] to exit.
Devices and Optional Modules
Programming options in this section relate to the keypads
and other devices which may be connected to your alarm
system. Your installer will advise you on the exact makeup and
conguration of your system.
Devices > Commands >
LAN Status
MENU 6-0-0
This option provides a listing of all of the devices and modules
connected to your system. Using this option it is poosible to view
the voltage, temperature and other information about each of
the modules.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [0] + [0].
Kp001 Keypad 001
Kp002 Keypad 002
Ox001 OutputX 001
Press
 OK or MENU
2. Use the [] and [] keys to select the device that you want
to view, then press [OK] to select.
3. The display will show each parameter for the device one
at a time on the third line of the screen.
Keypad 001 Kp001
Graphic + Prox V1.01
Volts = 13.87
Press OK or MENU
4. Press [OK] or [MENU] to exit.
Devices > Keypads >
Volume
MENU 6-1-0
This menu allows you to adjust the volume of the keypad’s buzzer.
Each keypad will need to have their volume adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [1] + [0].
The keypad will display:
L
Keypad 001 Volume
Press
SAVE
OK
to
H
2. Use the [] and [] keys or use the [] and [] keys to
increase or decrease the volume of the keypad buzzer
until the desired volume has been reached.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Devices > Keypads >
Contrast
MENU 6-1-1
This menu allows you to adjust the contrast of the keypad’s LCD
display. Each keypad can have their display adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [1] + [1].
The keypad will display the contrast screen.
L
Keypad 001 Contrast
Press
SAVE
OK
to
H
2. Use the [] and [] keys to adjust the bar until the
desired contrast is reached.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Devices > Keypads >
Backlight
MENU 6-1-2
This menu allows you to adjust the brightness of the keypad’s
LCD display backlight. Each keypad can have their display
adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [1] + [2].
The keypad will display the backlight screen.
L
Keypad 001 Backlight
Press
SAVE
OK
to
H
2. Use the [] and [] keys to adjust the bar until the
desired backlight is reached.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.