Solution16
Plus
24
Bosch Security Systems 03/10 BLCC100U
User Guide
System Events
Options in this section relate to programming of system wide
options and interpretation of system trouble events when and
if they occur. Some events such as open zones will appear and
single events while other may be grouped together. In this case
you need to drill down to see the specic detail for each event.
Your installer will advise you how to interrogate system trouble
events.
System > Commands >
Panel Status
MENU 7-0-0
The panel staus menu displays the panel software version
information as well as highlighting any system troubles that are
currently in eect. This is a view only location.
System > Commands >
System Trouble
MENU 7-0-1
The System Trouble Menu displays all current system troubles
in a list format. Some trouble events require you to drill down
to fully interpret while others such as an unsealled zone can
be interpreted at the top level. “Table 7: Control Panel Trouble
Messages” on page 25 lists the various trouble conditions that may
be displayed and their meanings
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [7] + [0] + [1].
The keypad will display a list of all current system and
non system trouble conditions.
To determine the system trouble condition, highlight the
panel number (P001 to P002) that you want to view using
the [] and [] keys, then press [OK] to select.
P001 System Trouble
Z001 Zone 1 Name
Z002 Zone 2 Name
Press
OK or MENU
To determine the non system (zone) trouble condition,
highlight the zone number Z001 to Z016) that you want
to view using the [] and [] keys, then press [OK] to
select.
P001 System Trouble
Z001 Zone 1 Name
Z002 Zone 2 Name
Press
OK or MENU
2. If viewing system trouble conditions, the keypad will
display similar to the following:
Panel 001 P001
Voltage= 13.9V Temp=36
Date And Time
Press OK or MENU
The third line of the keypad display scrolls between all
current system trouble events.
If viewing non-system trouble conditions, the keypad will
display similar to the following:
Zone 1 Name Z001
EOL = Open
Press OK or MENU
3. Press [OK] or [MENU] to exit the system trouble menu
command:
If there are no system troubles, the keypad will display:
There are no
System troubles.
Press
OK or MENU
Refer to the Trouble Messages table for a complete list of
trouble events and their meanings.
System > Commands >
History Log
MENU 7-0-2
This menu allows you to review the last 256 history events (from
most recent to least recent).
Each event will display:
Line 1 - Displays Event Number
- Date / Time
- Destination 1 and/or 2 report status (S= Sent, P =
Pending, F = Fail, A = Abort and L = Log Only).
Line 2 - Displays the source of the event (eg. zone name and
zone number or user name and user number)
Line 3 - Displays the event description.
To review the History Log enter programming mode (PIN +
MENU) then,
1. Press [MENU] + [7] + [0] + [2].
The keypad will display the most recent event stored in
the history log.
E001 Mon,01Oct 03:41 S1L2
Manual Test Report
Press
OK or MENU
2. Use the [] and [] keys scroll between history events.
3. Press [OK] or [MENU] to exit.
To Next Page
Loading...
