Solution16
Plus
22
Bosch Security Systems 03/10 BLCC100U
User Guide
Comms > Registration >
Customer
MENU 5-5-0
Reserved for future use
Email Reporting
In addition to Back to Base monitoring you can also congure
your Solution 16
Plus
to send selected reports to an email address
of your choice. To activate email reporting, simply enter the
email address in MENU 5-5-8 and then select the required report
types in MENU 5-5-9.
The Site Name in MENU 7-7-7 is used in the email subject line
when email reporting. You should also program this name to
make it easier to identify email sent from the Solution 16
Plus
panel.
To cancel email reporting simply remove the email address by
going to MENU 5-5-9 and then pressing the [OFF] key followed
by the [OK] key.
Currently email reporting functionality is only available
for panels located in Australia.
Comms > MyAlarm >
Email Address
MENU 5-5-8
This menu allows the master user to program an email address
that the system will send email reports to. A maximum of 80
characters can be used to program the email address.
1. Enter your Master PIN + [MENU].
2. Enter [5] + [5] + [8] + [OK].
The keypad will display the current email address.
Email P001
_
Press
OK to SAVE
3. Use the numeric, [0] to [9], [] and [] keys to enter or
change the email address as required.
At any time you can use the [] and [] keys to scroll through
the complete list of available characters.
To clear all characters from the cursor position to the right,
press the [OFF] key.
4. When the email address is complete, press [OK] to save
and exit, or press [MENU] to exit without saving.
To stop email reporting simply remove the email address or
disable all of the email options in MENU 5-5-9.
When entering an email address the @ symbol is
represented on the keypad display as .
To enter this character press the 1 key repeatedly until
the symbol appears in the display.
Comms > MyAlarm >
Email Options
MENU 5-5-9
This menu allows the master user to select which event types will
be reported using the email reporting function. By default the
rst 4 options are set to report via email. Follow the procedure
below to congure the required options.
Option Description Default
1 Open/Close Reports Send Reports
2 Zone Alarm Reports Send Reports
3 Zone Trouble Reports Send Reports
4 System Reports Send Reports
5 Access Reports Dont Send Reports
6 Reserved
7 Reserved
8 Reserved
Table 6: Email Options
1. Enter your Master PIN + [MENU].
2. Enter [5] + [5] + [9] + [OK].
The keypad will display the list of current options. Options
with a preceeding tick mark are selected.
Open / Close
Zone Alarm
Zone Trouble
Press
OK ON OFF MENU
3. Use the [] and [] keys to highlight the feature that you
want to program, then use the [ON] and [OFF] keys to turn
on and o the features as required.
4. When all email options are programmed, press [OK] to
save and exit, or press [MENU] to exit without saving.
Comms > Periodic Test >
Send Test Report
MENU 5-9-0
This menu allows you to test the reporting functions of the
Solution 16
Plus
control panel by manually sending a ‘Test’ report
to the receiving party (i.e. security company monitoring station,
mobile telephone etc).
1. Enter [MENU] + [5] + [9] + [0].
The keypad will prompt that it is in the process of sending
a test report.
Comms testing in
progress. Please wait..
To Go Back Press OK
If the test is successful, the keypad will prompt:
To Next Page
Loading...
