Bosch Solution 16plus - Communications Setup; Comms Commands and Telephone Numbers

Solution16
Plus
18
Bosch Security Systems 03/10 BLCC100U
User Guide
Z001 Zone 1 Name
Test Successful
Press OK or MENU
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Outputs
The Solution 16
Plus
control panel has up to a maximum of 8
outputs. 4 outputs are available as standard with an additional
4 available when the optional output expander is tted. Your
installer will advise you on the exact makeup and conguration
of you system.
Outputs > Commands >
Output Status
MENU 4-0-0
This menu allows you to view the status of each output.
Enter programming mode (PIN + MENU) then,
1. Ensure that the system is turned o.
2. Press [MENU] + [4] + [0] + [0].
The keypad will display a list of outputs that the status
may be viewed.
3. Using the [] and [] keys, highlight the output that you
want to view the status information, then press [OK] to
select. Alternatively, you can enter the output number
and then press [OK].
The keypad will display the following when the output is
o and OK:
Output 1 Name O001
Is Off and Ready
Press OK or MENU
The keypad will display the following when the output is
o and missing:
Output 1 Name O001
Is Off and Ready
Connection Trouble
Press OK or MENU
The keypad will display the following when the output is
ON and OK:
Output 1 Name O001
Is ON and Ready
Press OK or MENU
The keypad will display the following when the output is
ON and missing:
Output 1 Name O001
Is ON and Ready
Connection Trouble
Press OK or MENU
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Outputs > Commands >
Turn Output On/O
MENU 4-0-1
This menu allows you to turn outputs that have been
programmed by your security company on or o. These outputs
can be programmed to control outside lighting, pool pumps,
watering systems etc.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [4] + [0] + [1].
If a valid PIN is required, the keypad will prompt you to
enter your PIN.
2. Use the [] and [] keys to select the output name
that you want to change, then press [OK] to select.
Alternatively, you can enter the output number, then
press [OK].
3. To toggle the output on or o, use the [ON] and [OFF]
keys.
The keypad will display the following when the output is
o:
Output 1 Name O001
Output is OFF,
To Turn ON,Press ON.
To Go Back Press OK
To turn the output on, press [ON].
The keypad will display the following when the output is
on:
Output 1 O001
Output is ON,
To Turn OFF,Press OFF.
To Go Back Press OK
To turn the output o, press [OFF].
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.