AUTODOME IP starlight 7000 HD Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 31
Bosch Security Systems Operation Manual 2016-07 | 1.0 | F.01U.283.679
Figure7.9: Pendant Arm to Power Box Hinge Alignment
2. Open the top hinge by pushing its pin lever up and holding it.
Notice!
Both Hinge Pins must be fully compressed to open (unlock) the hinges of the Pendant Arm
and before proceeding to the next step.
3. While continuing to hold the top hinge pin open and align the top and bottom hinges of
the Pendant Arm to their mating points on the Power Supply Box. See the illustration
above.
4. Once you have aligned the hinges, release the top hinge pin to engage its mating hinge on
the power box. Then release the bottom hinge pin from the Hinge Pin Stop to lock the
Pendant Arm to the Power Supply Box.
Warning!
Serious injury or death can occur if the hinge pins of the Pendant Arm are not fully engaged
(locked) to the Power Supply Box. Exercise caution before releasing the Pendant Arm.
To Next Page
Loading...
