AUTODOME IP starlight 7000 HD Installing the Roof Parapet and Pipe Mounts | en 47
Bosch Security Systems Operation Manual 2016-07 | 1.0 | F.01U.283.679
10. Thread the Dome Cap onto the down pipe and tighten securely. See the illustration
below.
Warning!
You must thread the Dome Cap onto the Down Pipe until it is tight. Failure to do so can result
in damage, serious injury, or death.
Figure8.23: Attach Dome Cap
1 Thread Sealant or tape
2 Dome Cap
11. Run a bead of RTV Silicon sealant around the down pipe/Dome Cap interface to seal any
gaps between the down pipe and the Dome Cap.
12. Proceed to Wire the Pipe Interface Board, page 49.
Notice!
Use a guy-wire to aid in stabilizing the Parapet Arm. Replace the 1/4 inch cap screw with a
threaded 1/4-inch stainless steel eye bolt (not supplied). Loop the guy-wire through the eye
bolt and attach both ends to anchor spots on the roof.
8.5 Installing the VG4-A-9543 Pipe Mount
This section details the installation steps for the VG4-A-9543 Pipe Mount. If you are installing
the Roof Parapet mount, refer to Installing the VGA-ROOF-MOUNT, page 45 for instructions.
Notice!
Customer must supply 1-1/2 inch (NPS) pipe threaded on both ends with a minimum length
of 5 inches (12.7 cm).
You must use Teflon tape for thread-sealing compound.
All screws shall be tightened securely.
To Next Page
Loading...
