Bosch VG5-7230-CPT5 - Wire the Interface Box

AUTODOME IP starlight 7000 HD Installing the In-Ceiling Mount | en 57
Bosch Security Systems Operation Manual 2016-07 | 1.0 | F.01U.283.679
Figure9.33: Secure Bracket Assembly
9.5 Wire the Interface Box
The Interface Box can be wired through the top or side. Use the supplied rubber plug to seal
the hole which will not be used to route wires.
Figure9.34: Interface Box Connections
After routing all video, control, power, and alarm wires:
1. Attach a 3/4-inch NPS (20-mm) conduit fitting to the hole in which you bring in the wires.
Be sure to thread the inside nut to the conduit fitting.
2. Route the video, control, power, and alarm wires through the conduit fitting and into the
Interface Box.