Bosch VG5-7230-CPT5 - Installing the In-Ceiling Mount; Description; Dimensions; Prepare Drywall Ceiling for Installation

AUTODOME IP starlight 7000 HD Installing the In-Ceiling Mount | en 55
Bosch Security Systems Operation Manual 2016-07 | 1.0 | F.01U.283.679
9 Installing the In-Ceiling Mount
9.1 Description
This chapter details how to install the camera in an In-Ceiling Mount. The In-Ceiling
AUTODOME camera is suitable for use in environmental air spaces. Refer to Installing the
Pendant Arm Wall, Corner, and Mast (Pole) Mounts, page 24, or refer to Installing the Roof
Parapet and Pipe Mounts, page 38 for these specific installations.
9.2 Dimensions
206.89
[8.145]
175.99
[6.929]
21.29
[0.838]
99.76
[3.928]
IP
78.04
[3.072]
IP
204.49
[8.051]
ø
74.65
[2.939]
HD
95.88
[3.775]
HD
mm
[in.]
ø
Figure9.29: AUTODOME 7000 Dimensions – In-ceiling
9.3 Prepare Drywall Ceiling for Installation
1. Choose the desired location to mount the camera.
2. Use the bracket Base Plate as a template to cut a 7 in. hole with a tolerance of ±1/8 in.
(177.8 mm ±2.2 mm) in the ceiling with a drywall utility saw or Jig Saw. Proceed to Wire
the Interface Box, page 57, for further instructions.
9.4 Prepare Suspension Ceiling for Installation
You must use the VGA-IC-SP In-ceiling Support Kit to install the camera In-ceiling housing into
a suspended or drop ceiling. This kit requires a separate purchase.
1. Choose the desired location to mount the camera.
2. Remove an adjacent ceiling tile.
3. Loosen the four (4) securing screws, located in the corners of the Bracket Assembly,
enough to hold the suspension bars but still allowing adjustment during installation.
4. Place the Bracket Assembly over the ceiling tile, which is used to mount the camera.
5. Snap the Bar Clips of the bracket to the ceiling rails.