Bosch VG5-7230-CPT5 - Replacing an In-Ceiling Rugged Polycarbonate Bubble

68 en | Replacing an In-ceiling Rugged Polycarbonate Bubble AUTODOME IP starlight 7000 HD
2016-07 | 1.0 | F.01U.283.679 Operation Manual Bosch Security Systems
11 Replacing an In-ceiling Rugged Polycarbonate Bubble
Notice!
The following instructions are for bubbles VGA-BUBBLE-CCLR and VGA-BUBBLE-CTIR (on
AUTODOME models VG4, VG5-1xx, and VG5-6xx).
1. Loosen the lock screw (item 1, below) in the trim ring using a P1 or smaller Phillips
screwdriver until the bubble can rotate freely.
2. Rotate the bubble counterclockwise approximately 1/4 turn until it releases from the in-
ceiling housing.
Notice!
For VGA-BUBBLE-CCLR and VGA-BUBBLE-CTIR, you must reuse the rings that came with the
bubble that you are replacing. Continue with steps 3 through 8.
3. Turn over the bubble and trim ring assembly so that you see the inside of the assembly.
4. Remove the four Phillips screws (item 2 below), using a P1 Phillips screwdriver, that
connect the bubble to the trim ring and set aside for later use.