92 en | Camera AUTODOME IP starlight 7000 HD
2016-07 | 1.0 | F.01U.283.679 Operation Manual Bosch Security Systems
19 Camera
19.1 Installer Menu
Factory defaults
Click the Defaults button to restore the configuration settings defined in the camera’s web
server to their default values. A confirmation screen appears. Allow 5 seconds for the camera
to optimize the picture after a mode reset.
19.1.1 Positioning
Coordinate system
Select the appropriation option. Enter the appropriate additional values in the additional input
fields that appear depending on the options selected. Refer to the following table.
Option Additional Input field
Not set
Cartesian X [m]
Y [m]
Z [m]
Azimuth [°]
WGS 84 Latitude
Longitude
Ground level [m]
Azimuth [°]
19.2 Encoder Profile
For the video signal encoding, you can select a code algorithm and you can change the presets
for the profiles.
You can adapt the video data transmission to the operating environment (for example network
structure, bandwidth, data load). To this end, the camera simultaneously generates two data
streams (Dual Streaming), which compression settings you can select individually, for example
one setting for transmissions to the Internet and one for LAN connections.
Pre-programmed profiles are available, each giving priority to different perspectives.
You can change individual parameter values of a profile and you can also change the name.
You can switch between profiles by clicking the appropriate tabs.
Caution!
The profiles are rather complex. They include a large number of parameters that interact with
one another, so it is generally best to use the default profiles.
Change the profiles only once you are fully familiar with all the configuration options.
Note: In the default setting, Stream 1 is transmitted for alarm connections and automatic
connections.
Notice!
All parameters combine to make up a profile and are dependent on one another. If you enter a
setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.
To Next Page
Loading...
