80 en | Connection AUTODOME IP starlight 7000 HD
2016-07 | 1.0 | F.01U.283.679 Operation Manual Bosch Security Systems
Audio Line Level Output Connections
1. Connect the audio line level input of the audio output device (for example, an amplified
speaker or a PC line level input) to the Audio_Out+ (RXD) output terminal.
2. Connect the audio line level output signal ground to the Audio_Out- (TXD) output
terminal.
Figure15.50: Connections for audio over an Ethernet network
1 Audio_In- (C-) 7 AUTODOME Data In/Out
2 Audio_In+ (C+) 8 P105/P106 Connector
3 Earth Ground 9 Audio Out
4 Audio_Out+ (RXD)
5 Audio_Out– (TXD)
6 Signal Ground
Notice!
Separate the audio cables from the AC power lines to avoid noise.
To configure audio on the camera, refer to Basic Mode: Audio or Audio.
To Next Page
Loading...
