AUTODOME IP starlight 7000 HD Configuration | en 83
Bosch Security Systems Operation Manual 2016-07 | 1.0 | F.01U.283.679
Notice!
Depending on the PC network security settings, the user may need to add the new IP address
to the browser’s trusted sites list for the controls to operate.
Using the Web Server
1. Set the IP address on the network device to 192.168.0.10 to ensure that the network
device and the camera are on the same Subnet.
2. Launch your web browser (such as Microsoft Internet Explorer) and navigate to the
following URL: http://192.168.0.1. The web browser opens the Live page for the camera;
a security warning message appears.
3. Select the box Always Trust, and then click YES.
4. Click Configuration at the top right of the page.
5. Select Network. The menu expands.
6. Select Network Access. The page Network Access opens.
7. Configure the settings on this page based on the addresses provided by your local
network administrator.
4 Click Set and Reboot. The camera will reset (go through the homing sequence, which
usually takes 30 seconds to complete), and then the Live page appears, with updated
video and the new IP address.
Notice!
Click the Help on this page? link if you need more information.
About the Configuration Page
The Configuration page is used to configure the unit and the application interface.
Navigation
1. Click one of the menu items in the left window margin. The corresponding submenu is
displayed.
2. Click one of the entries in the submenu. The web browser opens the corresponding page.
Making Changes
Each configuration screen shows the current settings. You can change the settings by entering
new values or by selecting a predefined value from a list field.
Not every page has a Set button. Changes to pages without a Set button are set immediately.
If a page does show a Set button, you must click the Set button for a change to take effect.
Notice!
Save each change with the associated Set button.
Clicking the Set button saves the settings only in the current field. Changes in any other fields
are ignored.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1. Make the desired changes.
2. Click the Set and Reboot button. The camera reboots and the changed settings are
activated.
All settings are backed up in camera memory so they are not lost even if the power fails. The
exception is the time settings, which are lost after 1 hour without power if no central time
server is selected.
To Next Page
Loading...
