ACOUSTIC NOISE CANCELLING
24
|
ENG
TAP CONTROL FOR TALK-THROUGH COMMUNICATION
When you need to focus on interpersonal communication coming from a specific
direction, you can automatically set noise cancellation to LOW in one earcup.
NOTES:
• By default, the TAP CONTROL operation switch is set to OFF.
• Tap Control is available only when the Acoustic Noise Cancelling (ANC) switch is in
the HIGH or MED position.
• Tap Control is disabled during extreme levels of ambient noise to ensure proper
noise reduction performance and intercom communication quality. However, you
can still set the noise cancellation level to LOW in both earcups using the Acoustic
Noise Cancelling (ANC) switch (see page 23).
1. Make sure the Acoustic Noise Cancelling (ANC) switch is in the HIGH or
MED position.
2. Inside the control module battery compartment, set the TAP CONTROL switch to
ON. See “Change the operation switches” on page 28.
3. Firmly double-tap the outside of the earcup.
2x
To Next Page
Loading...
