Bose Panaray 502C - Page 7

7
SPECIFICATIONS
502C Controller Specifications (continued)
Input Impedance: Balanced input, -10 dB level - 14k Ohms
Balanced input, +4 dB level - 6k Ohms
Unbalanced input (+ input), -10 dB level: 12k Ohms
Unbalanced input (+ input), +4 dB level: 4k Ohms
Output Impedance: 100 Ohms nominal
Input Level: -10 dB or +4dB, selectable
Output Level: 8.0 Vrms maximum into 600 Ohms
Low Frequency (LF) Output Mode: Sum or normal
LF Output Level: -18 dB to +3 dB, variable
Crossover Frequency: 140 Hz (Bi-amp), Roll-off slope: -18dB/octave
THD: Midrange distortion of HF output: - 0.1% at 5V, 600 Hz
Low frequency distortion of LF out: - 0.1 % at 5V, 80 Hz
Output Noise: Bi-amp mode, HF outputs - 90µV
Bi-amp mode, LF outputs - 40µV
Passive mode, - 90µV
Offset: All channels - 15mV
Power Requirements: 120 VAC,50/60 Hz, 12 watts (US/Can)
230 VAC,50/60 Hz, 12 watts (Euro)
100 VAC,50/60 Hz, 12 watts (Japan)
240 VAC,50/60 Hz, 12 watts (Aus/UK)