21
Appendix
Restoring the Factory Default Settings
(Factory Reset)
Not only can you return all of the settings to the values in eect
when the RC-5 was shipped from the factory, you can also specify
the items to be reset.
* When you execute “Factory Reset,” the settings you made will
be lost. In advance, back up important data to your computer.
1. Press the [SETUP] button.
The SETUP screen appears.
SETUP
GENERAL
J
2. Turn the [MEMORY/LOOP LEVEL] knob to select
“F.RESET,” and press the [MEMORY/LOOP LEVEL]
knob.
F.RESET
MEMORY
J
3. Turn the [MEMORY/LOOP LEVEL] knob to specify the
settings that will be returned to their factory-set state,
and press the [MEMORY/LOOP LEVEL] knob.
Value Explanation
MEMORY Memory 1–99
SYSTEM System settings
MEM+SYS Memory 1–99 and system settings
A conrmation message “ARE YOU OK?” appears.
* If you decide not to execute the factory reset, select “CANCEL”
and press the [MEMORY/LOOP LEVEL] knob.
4. Turn the [MEMORY/LOOP LEVEL] knob to select “OK,”
and press the [MEMORY/LOOP LEVEL] knob.
The factory reset is executed.
* Do not turn o the power while the “EXECUTING...” message is
shown.
Once the factory reset is complete, you are returned to the Play
screen.
Changing the Battery
9 V Battery
1. Hold down the pedal and loosen the thumbscrew ,
then open the pedal
upward.
* The pedal
can be opened without detaching the thumbscrew
completely.
2. Remove the old battery from the battery housing ,
and remove the battery snap
connected to it.
3. Connect the battery snap to the new battery, and
place the battery inside the battery housing.
* Be sure to carefully observe the battery’s polarity (+ versus -).
4. Slip the coil spring
onto the spring base
on
the back of the pedal, and then close the pedal.
* Carefully avoid getting the battery snap cord
caught in the
pedal, coil spring, and battery housing.
5. Insert the thumbscrew into the guide bush hole
and tighten it securely.
To Next Page
Loading...
Need help?
General
