9
Editing a Memory
MEMORY Parameters
LOOP
Parameter Value (Bold: default) Explanation
REVERSE
OFF, ON
Species conventional playback (OFF) or reverse playback (ON).
* When REVERSE is set to “ON,” you won’t be able to switch to overdubbing after a
recording has been completed.
1SHOT
Species whether the track playback will be one-shot or not one-shot (conventional loop playback).
OFF Conventional loop playback.
ON
The phrase will play only once from the beginning to the end of the track, and then
stop automatically (One-Shot Playback).
If you press the pedal switch during playback, playback will begin again from the
beginning of the track (Retrigger Playback). Overdubbing cannot be carried out.
LEVEL
0–100–200
Adjusts the playback level of the track.
* You can also use the [MEMORY/LOOP LEVEL] knob to adjust the playback level.
REC ACTION
Species the order in which record/playback/overdub are switched when you press the pedal switch.
REC->DUB
Operation will switch in the order of Recording 0 Overdubbing 0 Playback.
REC->PLAY
Operation will switch in the order of Recording 0 Playback 0 Overdubbing.
DUB MODE
Species the overdubbing method.
OVERDUB
The new performance is layered onto the prerecorded track.
If overdub is repeated, the next performance is layered on top of the previous material,
allowing you to create an ensemble in a single track.
REPLACE
Track with existing recordings is overwritten as new track is recorded over them.
Overwriting takes places while the previously recorded track is played back, allowing
you to achieve a kind of delay eect similar to that obtained from an eects processor.
AUTO REC
“AUTO REC” (auto record) starts recording when there is audio input from your guitar performance.
OFF Recording will begin the instant you press the pedal switch.
ON
The display shows that you have entered record standby mode when you press the
pedal switch. Once you start playing, the display shows that you are now in recording
mode, and recording begins.
START
Species whether playback starts with a fade-in or immediately when the track plays.
IMMEDIATE Playback starts immediately.
FADE IN
Playback starts while fading in.
* You can use “FADE TIME” to specify the length of the fade-in.
STOP
Species how the track will stop when you press the pedal switch.
* You can’t overdub during the time until playback stops.
IMMEDIATE Playback will stop immediately.
FADE OUT
Playback will fade out and then stop.
* You can use “FADE TIME” to specify the length of the fade-out.
LOOP END Playback will continue to the end of the loop, and then stop.
FADE TIME
˜, ˙, ¸, ˇ, 1MEAS–2MEAS–
64MEAS
Species the fade-in/out time as a number of measures when START is set to “FADE IN”
or STOP is set to “FADE OUT.”
MEASURE
You can specify the number of measures for a track.
When recording along with rhythm sounds, it’s convenient to specify the number of measures before you record,
so that looping will occur at the specied measure length, even if you don’t operate the switch when you’ve
nished recording.
FREE
The number of measures will be set automatically, corresponding to the length of the
recording.
1MEAS– The number of measures will be set manually.
To Next Page
Loading...
Need help?
General
