5
Creating a Loop Phrase
Recording
Getting ready to record
Turn the [MEMORY/LOOP LEVEL] knob to select a memory.
Memory
01
01
Screen Status
Blue Empty track
White Track contains data
Memory number
Memory name
Basic operation
Recording
Screen: Lit red
Record your guitar
performance.
Playback
Screen: Lit green
Play back a phrase as a loop.
Pressing the pedal switches
the unit to overdubbing.
Overdubbing
Screen: Lit yellow
Layer your performances while
the phrase plays as a loop.
Pressing the pedal switches the
unit to playback.
Stop
Screen: Lit white
During overdubbing or loop
playback, you can stop by
pressing the pedal twice in
succession.
* Press the pedal twice within one
second.
Press Press Press
Press twice
Technique for stopping
Example: When you want to stop at the end of
a measure with a 4/4 time signature
Press the pedal one time at the beginning of he
fourth beat, then press it again at the beginning
of the rst beat of the next measure.
1st
time
2nd
time
1 2 3 4 1
Stop
NOTE
The maximum recording time is approximately 1.5 hours for one track, and approximately 13 hours total for all memories. If you exceed
the maximum recording time, recording or overdubbing ends at that point, and the unit switches to loop playback.
Undo/Redo
Hold down the pedal two seconds or longer during playback or overdubbing to Undo (cancel the recording or the last overdubbing).
Hold down the switch once again for two seconds or longer to Redo (cancel the Undo).
Clear
Hold down the pedal two seconds or longer while stopped, the recorded phrase is cleared.
To Next Page
Loading...
Need help?
General
