Changing the batteries
8
Changing the batteries
Use of battery
● If operating this unit on batteries, please use alkaline batteries.
● If you handle the battery (batteries) improperly, you risk explosion and fluid leakage. Make sure that you carefully
observe all of the items related to the battery (batteries) that are listed in leaflet “USING THE UNIT SAFELY” and
“IMPORTANT NOTES”.
● This device contains a battery when shipped from the factory. This is a test battery, which may not last as long as a
new one.
● If the batteries run extremely low, the sound may distort, but this does not indicate a malfunction. If this occurs,
please replace the batteries / use the AC adaptor sold separately.
When operating on battery power only, the unit’s CHECK indicator will become dim when battery power gets too low.
Replace the battery as soon as possible.
● If you notice noise when the unit is running on battery power, this may be because the battery is almost depleted. Try
replacing the battery or using an AC adaptor sold separately.
● If the CHECK indicator keeps switching on and off when the unit is running on battery power, this may be because the
battery is almost depleted. Try replacing the battery or using an AC adaptor sold separately.
Replacing the battery
* Batteries should always be installed or replaced before connecting any other devices. This way, you can prevent malfunction
and damage.
1.
Hold down the pedal and loosen the thumbscrew, then open the pedal upward.
You don’t need to take the thumbscrew out completely to open the pedal.
2.
Remove the old battery from the battery housing, and remove the snap cord connected to it.
3.
Connect the battery snap to the new battery, and place the battery inside the battery housing.
Be sure to carefully observe the battery’s polarity (+ versus -).
4.
Slip the coil spring onto the spring base on the back of the pedal, and then close the pedal.
Carefully avoid getting the snap cord caught in the pedal, coil spring, and battery housing.
5.
Finally, hold down the pedal while tightening the thumbscrew into the guide bush hole.
To Next Page
Loading...
