EasyManua.ls Logo

Bradco SG30 - Equipment Safety Precautions (Continued); Transporting the Stump Grinder; Maintaining the Stump Grinder

Default Icon
65 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EQUIPMENT SAFETY PRECAUTIONS
OPERATING THE STUMP GRINDER (continued)
When operating on slopes, drive up and down, not across. Avoid steep hillside
operation, which could cause the prime mover to overturn.
Reduce speed when driving over rough terrain, on a slope, or turning, to avoid
overturning the vehicle.
An operator must not use drugs or alcohol, which can change his or her alert-
ness or coordination. An operator taking prescription or over-the-counter drugs
should seek medical advice on whether or not he or she can safely operate
equipment.
TRANSPORTING THE STUMP GRINDER
Travel only with the attachment in a safe transport position to prevent uncon-
trolled movement. Drive slowly over rough ground and on slopes.
When driving on public roads use safety lights, reectors, Slow Moving Vehicle
signs etc., to prevent accidents. Check local government regulations that may
affect you.
Do not drive close to ditches, excavations, etc., cave in could result.
Do not smoke when refueling the prime mover. Allow room in the fuel tank for
expansion. Wipe up any spilled fuel. Secure cap tightly when done.
Use extra care when loading or unloading the machine onto a truck or trailer.
Disconnect hydraulic couplers during transportation.
MAINTAINING THE STUMP GRINDER
Before performing maintenance, lower the attachment to the ground, turn off the
engine, remove the key and apply the brakes.
Never perform any work on the attachment unless you are authorized and quali-
ed to do so. Always read the operator service manuals before any repair is
made. After completing maintenance or repair, check for correct functioning of
the attachment. If not functioning properly, always tag “DO NOT OPERATE” until
all problems are corrected.
Worn, damaged, or illegible safety decals must be replaced. New safety decals
can be ordered from your nearest dealer.
Never make hydraulic repairs while the system is under pressure. Serious per-
sonal injury or death could result.
Never work under a raised attachment.
9715 7-29-14-2
75578
9

Related product manuals