Bradco SG30 - Lubrication; Daily; Every 8 Hours; Weekly

LUBRICATION
9775 7-29-14-2
GENERAL INFORMATION
 Economicalandefcientoperationofanymachineisdependentuponregularandprop-
erlubricationofallmovingpartswithaqualitylubricant.Neglectleadstoreducedefciency,
wear,breakdownandneedlessreplacementofparts.
DAILY / EVERY 8 HOURS
 Allpartsprovidedwithgreasettingsshouldbelubricatedevery8hours.Ifanygrease
ttingsaremissing,replacethemimmediately.Cleanallttingsthoroughlybeforeusingthe
greasegun.
IMPORTANT: Avoid excessive greasing. Dirt collects on exposed grease and greatly in-
creases wear. After greasing, wipe off excessive grease from ttings.
LUBRICATION SYMBOL
Lubricatedailyorevery8hoursofoperation,whichevercomeslast,withSAEMulti-PurposeLubri-
cantorequivalentSAEMulti-Purposetypegrease.
CAUTION! SHUT OFF ENGINE AND REMOVE KEY BEFORE LUBRICATING EQUIP-
MENT.
8
WEEKLY
 Theoillevelinthegearboxshouldbecheckedonceaweek.Fillasnecessarywith80-
90weightgearlubricant.
TO CHECK:
 Removeaccesscoverfromfrontofframe.Removepipeplugfromendofgearbox.Lubricantshouldbeat
thesamelevelastheplug.
TO ADD:
 Removepipeplugfromthegearboxandadd80-90weightgearlubricantuntillevelwithplug.Replace
pipeplug.NOTE: Removing vent plug when lling will speed up the lling process.
BOTH ENDS OF
HYDRAULIC CYLINDERS
PIVOT POINTS
8
8
IMPORTANT: DO NOT OVERFILL,
AS TOO MUCH LUBRICANT MAY
RUPTURE THE GEAR BOX SEALS.
PIPE
PLUG
VENT PLUG
GEARBOX
ADD LUBRICANT
TO THIS LEVEL.
75578
21