Bradco SG30 - Troubleshooting; Motor Will Not Operate.; Wheel Rotates Sluggishly.; Leaking Oil.

TROUBLESHOOTING
9732 8-4-14-2
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Motor will not operate. Auxiliary hoses not hooked up to
the skid steer.
Obstruction in hydraulic lines.
Skid steer auxiliary valve not en-
gaged.
Engage Couplers
Remove obstruction and replace if
necessary.
Engage auxiliary valve.
Wheel rotates sluggishly. Insufcient hydraulic ow from the
skid steer.
Damaged quick coupler.
Oil lter on skid steer is dirty.
Internal motor leakage.
Gearbox Failure.
Refer to skid steer's owners
manual.
Replace if necessary.
Refer to skid steer's owners
manual.
Call Bradco service department.
Call Bradco service department.
Leaking Oil.
Loose or damaged hydraulic line.
O-Rings on ttings damaged.
Fittings loose or damaged.
Cylinder seals damaged.
Motor seals damaged.
Tighten or replace.
Replace if necessary.
Tighten or replace.
Replace cylinder seals.
Call Bradco Service Department.
Insufcient power. Insufcient hydraulic ow from the
skid steer.
Relief valve setting adjusted too
low.
Oil lter on skid steer is dirty.
Refer to skid steer's owners
manual.
Refer to skid steer's owners
manual.
Refer to skid steer's owners
manual.
Cylinders operate in the
wrong direction.
Hoses from the valve to the skid-
steer incorrectly connected.
Incorrect wiring from the joystick
control.
Switch couplers at the skid steer
end.
Check wiring diagram and correct.
Cylinders speed is either
too fast or too slow.
Cylinder speed adjusted incorrectly. Adjust the cylinder speed knob on
the control valve.
28
75578