Bradco SG30 - Troubleshooting (Continued); Excessive Oil Temperature.; Excessive Vibration; Cylinders Will Not Function.

TROUBLESHOOTING
9733 8-4-14-2
PROBLEM POSSIBLE CAUSE
POSSIBLE SOLUTION
Excessive oil temperature. Hydraulic oil level too low.
Excessive stalling of cutting wheel.
Obstruction in hydraulic lines.
Hydraulic oil or oil lter in skid steer
is dirty.
Relief valve setting adjusted too
low.
Couplers not engaged.
Refer to skid steer's owners
manual.
Decrease cutting depth and swing
speed.
Remove obstruction and replace if
necessary.
Refer to skid steer's owners
manual.
Refer to skid steer's owners
manual.
Engage couplers.
Wheel rotates in the wrong
direction.
Hoses are switched at the motor.
Switch motor hoses.
Excessive Vibration Broken, damaged or missing teeth.
Bent gearbox shaft.
Replace as necessary.
Call Bradco Service Department.
Cylinders will not function. Faulty switch or electrical
connection.
Faulty control valve coil.
Damaged spool in control valve.
Repair or replace as necessary.
Replace coil.
Replace spool.
75578
29