DECALS
DECAL PLACEMENT
9780 7-29-14-3
GENERAL INFORMATION
The diagram on this page shows the location of the decals used on your attachment.
The decals are identied by their part numbers, with reductions of the actual decals located on
the following pages. Use this information to order replacements for lost or damaged decals. Be
sure to read all decals before operating the stump grinder. They contain information you need
to know for both safety and attachment longevity.
IMPORTANT: Keep all safety decals clean and legible. Replace all missing, illegible or damaged safety decals.
When replacing parts with safety decals attached, the safety decals must also be replaced.
REPLACING SAFETY DECALS: Clean the area of application with a nonammable solvent, then wash the same
area with soap and water. Allow the surface to dry. Remove the backing from the safety decal, exposing the adhe-
sive surface. Apply the safety decal to the position shown in the diagram above and smooth out any bubbles.
#40782
#40678
#40151
#40149
#4495
#4338
#40590
(STANDARD FLOW
UNITS ONLY)
SERIAL TAG
LOCATION
#40150
LOGO
#40782
#40719
MODEL NUMBER
To Next Page
Loading...
