9774 7-29-14-2
NOTE: The cutting depth of each pass will be determined by the type of tree. Certain
varieties of trees will allow for a deeper cut than trees containing a lot of sap.
5. Swing the cutting wheel to the left across the top of the stump on the edge closest to
the skid steer. Lower the grinder another 1 to 1-1/2" and swing the cutting wheel back
across the stump to the right.
6. Continue cutting in this manner. If the wheel stalls, reduce the depth of the cut. Move
the skid steer as required to allow cutting a new area.
NOTE: Do not move into the stump while making a cross sweep. Machine and/or tooth
damage could result from motor overload.
NOTE: Make shallow cuts when cutting surface roots. Large chips can be broken off
and thrown if the cut is too deep.
GROUSER PAD
STUMP
STUMP GRINDER
START NEW CUT AS
DESIRED
OPERATION
STUMP GRINDER
To Next Page
Loading...