Branson F42r - Transmission Case Assembly Components Disassembly

4
-
51
42hW-201601
CHAPTER 4 TRANSMISSION
4
3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
K42W434A
K42W431A K42W433A
K42W435A
K42W432A
1.Removethemainshiftleverassembly(1). 2. Removetheshuttleshift(1),oilsealcover(2)of
mainshaftandplate(3).
3.Removethereverseidleshaft(1)andreverseidle
gear(2)fromtheplate.
5.3 TRANSMISSION CASE ASSEMBLY COMPONENTS DISASSEMBLY
When installing the main shift lever assem-
bly, set the brake plate protrusion (A) of the
PTO clutch pack into the groove of the case.
The brake plate (2) of the PTO clutch pack is
set apart from the PTO clutch and xed into
the groove while the rear PTO is in operation.
Only the PTO clutch pack body is rotated in
this state. When the rear PTO is turned off in
this state, the PTO clutch pack stops rotating
as well. However, it may be rotated further by
inertia of the rotating rear implement. To pre-
vent such rotation by inertia, the PTO clutch
is equipped with the brake plate. The brake
plate is combined with the PTO clutch pack
by compression of the piston returned by the
internal spring when the PTO clutch is disen-
gaged.
•
•
