Branson F42r - Check the Main Function; Visual Check; Lubricating Oil

2
-
10
42hW-201601
CHAPTER 2 ENGINE 3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
2.2 CHECK THE MAIN FUNCTION
Check the main function is the best way for performance guarantee and long life of engine.
Please note the following information to the engine to maintain.
•
2.2.1 VISUAL CHECK
Visual check of around the engine: conrm the fuel, lubricating oil, coolant system, fuel and water leakage.
Check the hose of the each part, V-belt, and the tightening status of clamp.
Check the damage of components or loosening the bolt &nut.
If you have trouble when a visual check, please refer to this manual for repairing it.
•
•
2.2.2 LUBRICATING OIL
Diesel engine operate under unfavorable conditions than gasoline engine, so should be used the proper oil.
If defective oil is used or lubricating oil is not changed regularly, accelerated wear of moving components
and engine life may be seriously shortened.
Oil viscosity grade use the class SAE 15W-40 , above API CJ-4 level (Final Tier4) or above API CG-4 level
(StageⅢA).
* Please refer to next graphic and use the proper oil.
•
•
•
K25W229A
Before engine operating, check the lubricating oil level whether it is set at the right level between the L(low)
mark and the H(high) mark. If necessary, add lubricating oil. If the oil is contaminated or viscosity is low, it
should be changed.
1) While checking the lubricating oil, keep the engine horizontal.
2) Wait for about 15 minutes after shutting off the engine to check the oil level.
3) Check the oil level 5~6 minutes later after relling the lubricating oil.
•