Branson F42r - Tire Inflation Pressure; Checking Toe-In; Adjusting Front Wheel Toe-In

42hW-201601
1
-
39
CHAPTER 1 GENERAL INFORMATION3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
1
8.2.25 ADJUSTING FRONT WHEEL TOE-IN
Unscrew the mounting nut (1) on the tie rod.
Turn the rod (2) inwards or outwards. (Two rods
should be same in length.)
Adjust the toe-in and tighten the mounting nut (1).
1.
2.
3.
F42W149A
8.2.23 TIRE INFLATION PRESSURE
Per formance and expectancy of life of tires
depend on maintaining tire's inflation pressure
properly.
If tire inflation pressure is insufficient, it can
cause premature wear. If it is excessive, it can
reduce traction and increase wheel slip.
The specied tire pressure is different not only
by working environment and load, but also by
tractormodels.Makesuretofollowthespecied
standardinationpressuresetinthismanual.
1.
2.
3.
STANDARD
Front
wheel
2.0 kg/cmcm
2
(28.44 psi)
Rear
wheel
1.3 kg/cmcm
2
(18.49 psi)
WITH LOADER
Front
wheel
3.0 kg/cmcm
2
(42.67 psi)
Rear
wheel
2.0 kg/cmcm
2
(28.44 psi)
8.2.24 CHECKING TOE-IN
Park the machine on level ground.
Measure the front distance (A).
Measure the rear distance (B).
The difference (B- A) between the front distance
(A) and rear distance (B) should be over 4 - 8
mm (0.157 - 0.314 in.).
1.
2.
3.
4.
Front
6015W162A
(A) Front distance (B) Rear distance
Front