10
English
8.2 Mounting instructions (Large cradle only)
Mounting hardware not included.
The large cradle (2 box storage) can be mounted as an easily removable wall hanger or a permanent wall
mount. All mounting must be done into a wall stud. To mount the cradle the following items are needed:
• 2 #8 wood or sheet metal, pan head screws, 3.2 cm (1.25”) long
• Ruler (or tape measure could be substituted)
• Screwdriver to match drive of screws
1
Remove probe cover box carrier from
the cradle by rotating the probe cover box
carrier forward.
2
Mount to wall:
• Removable wall hanger:
Locate the stud on the wall. Mount the 1st screw
in position 1 and the 2nd screw in position 2a.
• Permanent wall mounting:
Locate the stud on the wall. Mount the 1st screw in position
1 and the 2nd screw in position 2b. Tighten screws.
Note: Permanent mounting is not recommended if using
the charging station to access the security function, other
advanced functions or charge the rechargeable battery.
3
Place probe cover box carrier back in cradle
by lining up the brackets and pushing down.
Note: For a mounting template please reference
the PRO 6000 thermometer CD.
8.3 Tether installation
A kit to tether the thermometer to the cradle is available separately.
Installation instructions are provided with the tethering kit. Contact Welch Allyn for details.
107 mm (4.21")
126 mm (4.95")
1
2a
2b
To Next Page
Loading...
