Braun ThermoScan PRO 6000 - Error Messages and Solutions

13
English
10. Controls
10.1 Memory
Press the MEMORY button to reveal the last completed temperature.
The temperature will show with a MEM indicator until the MEMORY
button is pushed again, a new probe cover is applied, or the
thermometer enters sleep state. Memory can also be accessed from
the thermometer sleep mode and will display for 5 seconds before
returning to sleep.
10.2 C/F (Celsius/Fahrenheit)
Once the temperature scale has been set (See 11.1 Default
temperature scale), the alternative scale can be quickly referenced
at any time while a temperature is displayed.
1
If the temperature scale is set to Celsius, press and release
C/F button to view the temperature in Fahrenheit.
If the temperature scale is set to Fahrenheit, press and release
C/F button to view the temperature in Celsius.
2
Press and release the C/F button again to revert back to
default scale.
NOTE: If Temperature Conversion is disabled, refer to the
Service Manual for more information.
Mem
C / F
Mem
C / F
Mem
C / F
Mem
C / F
7
Remove used probe cover by pressing Probe Cover
Ejector button .
To achieve accurate measurements, use a new, clean probe cover for
each measurement.
To take another measurement, place a new, clean probe cover on the
thermometer. If no action is taken the thermometer will enter SLEEP
mode after 10 seconds or upon return to the thermometer cradle or
host device.