Bresser T-REX2 - Generating Automatic Supports; Manually Adding Supports; Removing All Supports

www.bresser.de
54
② Automatic supports
Click the [Auto Supports] button. The software evaluates the positions where
supports are required and creates corresponding supports in tree format or linear
format. For a model with supports, the existing supports are removed and new ones
are created.
③ Adding supports
Supports are added when you click the [Add] button. Position the mouse pointer at
the point where a support is required, click the left mouse button to select the starting
point for the support, hold down the left mouse button and drag the mouse. The
column preview opens (if no column is required for the area or if the angle of the
column is too large, this is highlighted in the column view). Release the left mouse
button. If the support column is not suitable for a model, the support is created at the
starting and end points (the highlighted support in the preview does not create a
support structure).
④ Removing supports
Click on [Clear Supports]. All supports are then deleted. You can cancel this
deletion processby clicking on [Undo] or by pressing the key combination Ctrl+Z.