3
Safety Information
WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling,
installing, and operating the dispenser.
WARNING: This product dispenses water at very high temperatures. Failure to use properly can cause
personal injury. When operating this dispenser, always exercise basic safety precautions,
including the following:
• Prior to use, this dispenser must be properly assembled and installed in accordance with this
manual.
• For indoor use only. Keep the water dispenser in a dry place away from direct sunlight. Do NOT
use outdoors.
• Install and use only on a hard and level surface.
• Do NOT place the water dispenser in an enclosed space or cabinet.
• Do NOT operate the dispenser in the presence of explosive fumes.
• Only use properly grounded outlets.
• Do NOT use an extension cord.
• Always grasp the plug and pull straight out from the outlet. Never unplug by pulling on the
power cord.
• Do NOT use the dispenser if the cord becomes frayed or otherwise damaged. If the supply
cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly
qualified persons in order to avoid a hazard.
• To protect against electric shock, do NOT immerse cord, plug, or any other part of the
dispenser in water or other liquids.
• Do NOT use this dispenser with water that is microbiologically unsafe or of unknown quality.
• Water dispenser is compatible with 3- or 5-gallon (12- or 19-liter) water bottles.
• Clean up all water spills after loading or unloading water bottles into or from the dispenser.
• Ensure the water dispenser is unplugged prior to cleaning.
• Never allow children to dispense hot water without proper and direct supervision. Always
enable the child safety lock feature to prevent unsupervised use by children.
• Service should be performed only by a certified technician.
• Do NOT clean the dispenser with a water jet. Do NOT install in an area where a water jet could
be used.
WARNING: Keep ventilation openings in the dispenser enclosure or in the built-in structure clear of
obstruction.
WARNING: Do NOT use mechanical devices or other means to accelerate the defrosting process, other than
those recommended by the manufacturer.
• This dispenser should work under environmental temperatures from 39–104 °F (4–40 °C) and
humidity ≤90%.
• Never turn the dispenser upside down or lean it more than 45°.
• After turning o the red hot-water switch and the green cold-water switch, allow the dispenser
to sit idle for 3 minutes before turning on switches again.
To Next Page
Loading...
Need help?
General
