8
Dispense Hot Water and Activate Child Safety Lock
CAUTION: This unit dispenses water at temperatures that can cause severe burns. Avoid direct contact
with hot water. Keep children and pets away from the unit while dispensing. Never allow children
to dispense hot water without proper and direct supervision. Disable the heating feature by
switching the red hot-water switch to the O position.
NOTE: Water will take approximately 15-20 minutes after switching on to reach its hottest temperature. The
heating light will turn o once the water has been fully heated.
1� This water dispenser is equipped with a child safety feature in order to prevent inadvertent dispensing. To
enable dispensing of hot water, press and hold the red lock button and then place your mug or container
underneath the tap directly beneath the red lock button. Press and hold the hot water button.
2� Release the hot water button once your container is full.
Refill the Water Bottle
CAUTION: Do NOT dispense hot, room temperature, or cold water if the red light is flashing. You could
empty the tanks and cause the dispenser to overheat.
When the bottle indicator light on the front-right of the dispenser flashes red, it is time to refill your water bottle:
1� Open the dispenser cabinet door and slide the empty bottle out of the cabinet.
2� Remove the bottle adapter from the empty bottle and let the bottle adapter tube drip into the bottle. Once
dripping has stopped, place the bottle adapter on the hanger.
3� Follow the steps in Connect a Water Bottle, on page 6.
Troubleshooting Guide
Refer to the table below for possible problems and their solutions.
Problem Solution
The cold water is not cold.
• It takes approximately one hour after setup to dispense cold water.
• Make sure the power cord is properly connected to a working outlet.
• Language is confusing. Change to: Make sure the dispenser is at least 8 in.
(20 cm) from all walls, especially the back wall, and that there is free airflow
on all sides.
• Make sure green cold-water switch on back of dispenser is in the On position.
• If water still isn’t cold, call customer service at +1 844-257-4103 for assistance.
The hot water is not hot.
• It takes 15-20 minutes after setup to dispense hot water.
• Make sure the power cord is properly connected to a working outlet.
• Make sure red hot-water switch on back of dispenser is in the On position.
To Next Page
Loading...
Need help?
General
