Brivis Contour Series Installation Manual

Brivis 15 Evap AC IM
7.6 SETTING UP MULTIPLE COOLERS ON THE NETWORK
To ensure each Cooler is congured correctly to the Brivis Networker see the instructions below and refer to the
Brivis Networker Advanced Programming Manual No� 400 (Available on request from Brivis Customer Service)�
As the Brivis Networker is polarity sensitive when more than one Cooler is installed on a Brivis Networker all the
Coolers should be wired in parallel (see diagrams below)�
To ensure each Cooler is congured correctly to the Brivis Networker, each Cooler MUST BE:
•
Given a di󰀨erent specic identication number, starting at No. 1.
•
Designated to a zone (refer to the Brivis Networker Advanced Programming Manual No� 404)�
Each Cooler comes with the ID number set at number 1. To give it a new number, rst complete the installation
and wiring of all the units, as described previously and follow the instructions on the next page� (Changing an
Identication Number)
Brivis Networker
Cooler No�1
Cooler No�2
Cooler No�3
Cooler No�1
Brivis Networker
Typical Brivis AD Application
Typical Brivis Advance, Brivis Promina & Brivis Contour
Cooler No�3
Cooler No�2
7. NETWORK CONNECTION

Brivis Contour Series Specifications

General

Brand	Brivis
Model	Contour Series
Category	Freezer
Language	English