While removing a component with many assemblies, do from
outside to inside. Loosen firstly smaller assemblies.
For the complicated assemblies, such as gearbox, keep them in
a proper assembling order for the sake of easy assembly later.
Pay special attention to the key fitting position before disassembly. The components that are not
used any more shall be replaced on time before disassembly.
Length of bolts and screws are different for assemblies and protecting
plates. They shall be installed at correct positions. If confused, just put
the bolt inside the hole and see if it matches.
Fill lubricating grease into the groove during oil seal
installation. Check if the oil seal is smooth and if it is
possible to be damaged when installed.
KS MOTORCYCLES - http://ksmotorcycles.com
To Next Page
Loading...
