Broadcom Brocade X7-4 Director - Installing the 8 U Chassis MID-Mount Rack Kit for Two-Post Racks (XBR-DCX4 S-0126 and XBR-X64-0126); Time and Items Required

215 pages

To Next Page

To Previous Page

X7-4-Install-IG100 Installation Guide

Brocade

X7-4 Director Hardware Installation Guide

Figure 15: Device and 27–31 in. (68.58 to 78.74 cm) Kit Installed in Rack

1. Screw locations for 10-32 x .5 in. (1.27 cm) Phillips screw with blue Loctite on threads or 10-32 x .63 in. (1.60

cm) Phillips screw with square cone washer for racks that have rails with round holes.

NOTE

For rails with round holes, use the clip nuts on the rails for securing the 10-32 screws. For rails with square

holes, use the retainer nuts.

6. Reinstall the device door. See the procedures for removing and replacing the device door in this guide.

Installing the 8U Chassis Mid-Mount Rack Kit for Two-Post Racks

(XBR-DCX4S-0126 and XBR-X64-0126)

Time and Items Required

Allow approximately one hour to unpack and install the chassis in a rack.

X7-4-Install-IG100

Broadcom