X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
Installing the Device in the Rack
DANGER
Use safe lifting practices when moving the product.
1. Ensure that the door is removed from the port side of the device if installed. Refer to procedures for removing and
replacing the device door in this guide.
2. Ensure the device can be oriented so that the nonport side has access to intake air (cool).
3. Use a lift to raise the device to the correct level.
4. If applicable, lock the wheels of the lift.
5. Gently slide the device onto the saddle, ensuring that it remains supported during the transfer.
NOTE
The following figure shows mounting brackets from XBR-DCX4S-0126. Mounting brackets from the XBR-
X64-0126 kit install the same way.
Figure 20: Sliding the Device into the Mid-Mount Saddle
X7-4-Install-IG100
49
To Next Page
Loading...