X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
The following tools are required when installing the 8U Chassis Mid-Mount Rack Kit for Two-Post Racks (XBR-
DCX4S-0126 and XBR-X64-0126):
•
Torque wrench with No. 2 Phillips screwdriver tip
•
Flathead screwdriver
•
Hydraulic or assisted lift with a minimum raise of 140 cm (55 in.) and a minimum capacity of 113 kg (250 lbs)
Parts List
The following parts are provided with the 8U Chassis Mid-Mount Rack Kit for Two-Post Racks (XBR-DCX4S-0126 and
XBR-X64-0126).
NOTE
Not all parts may be used with certain installations depending on the device being installed.
Use parts in the following XBR-DCX4S-0126 rack mount kit to install the Brocade DCX-4S Director in a two-post rack.
Use parts in the following XBR-X64-0126 rack mount kit to install the Brocade Director in a two-post rack.
X7-4-Install-IG100
44
To Next Page
Loading...