4-3
Shut Down:
1. Turn cook/filter switch OFF.
2. *Turn gas control switch (2) OFF.
3. Turn gas shut-off (1) valve OFF.
MAIN BURNER
FLAME ADJUSTMENT
1. On the back of the fryer loosen the set
screws holding the clamps on each
side of the gas line support bracket.
2. While observing the flame, slowly slide
the gas pipe from front to back in the
support bracket. When the flame is as
blue as it can get, re-tighten the
clamps on each side of the support
bracket to hold the pipe in position.
Is the flame blue and settled on the face
of the burner? If it is, no further adjust-
ment is necessary otherwise continue.
3. Remove the LH side panel.
4. Using an adjustable wrench or large
pair of pliers, carefully change the
angle of the orifice holder mounting
bracket, up or down, so the orifice is
pointing down the middle of the mixer
tube.
5. Replace the side panel.
NOTE: To get the best flame several
adjustments, both up and down and front
and back, may be necessary.
broaster.com Manual #15458 5/02 Rev 2/14
To Next Page
Loading...
