BRONKHORST EL-FLOW Select Series - E-8000 Power Supply, Readout and Control; BRIGHT Readout and Control

Bronkhorst®
Instruction Manual EL-FLOW® Select 9.17.099F18
2.8.3 E-8000 power supply, readout and control
Using an E-8000 module, instruments can be
powered (100…240 Vac) and operated via RS232.
Most digital parameters and functions are
accessible via the display interface and the
control buttons.
This example uses the following components:
· 2x EL-FLOW® Select
· 2x RS232/power supply cable (art no.
7.03.016/7.03.538/7.03.539)
· E-8000 power supply, readout and control
module
Consult the E-8000 manual (document 9.17.076) for more information. This manual can be downloaded from the
Accessories and software section on the Bronkhorst® product pages (www.bronkhorst.com/products).
2.8.4 BRIGHT readout and control
Most digital parameters and functions are
accessible via the display interface and control
buttons of a BRIGHT readout and control
module (type B1 or B2). When a BRIGHT module
is installed, no other RS232 connection can be
established with the instrument.
This example uses the following components:
· EL-FLOW® Select
· BRIGHT readout and control module
· Plug-in Power Supply (PiPS, art no. 7.03.422)
Use the 9-pin D-sub connector on the side of the instrument to plug in the T-part that comes with the BRIGHT module.
Consult the BRIGHT manual (document 9.17.048) for more information. This manual can be downloaded from the
Accessories and software section on the Bronkhorst® product pages (www.bronkhorst.com/products).